Removing The Ibm Dual-Port 10Gb-T (Copper) Ethernet Adapter Or The Ibm Dual-Port 10Gb Sfp+ (Fibre) Ethernet Adapter - IBM System x3750 M4 Installation And Service Manual

Types 8722 and 8733

Hide thumbs Also See for System x3750 M4:

Table of Contents

Removing the IBM Dual-port 10Gb-T (copper) Ethernet Adapter

or the IBM Dual-port 10Gb SFP+ (fibre) Ethernet Adapter

This information provides instructions on how to remove the IBM Dual-port

10Gb-T (copper) Ethernet Adapter or the IBM Dual-port 10Gb SFP+ (fibre) Ethernet

About this task

To remove the IBM Dual-port 10Gb SFP+ (fibre) Ethernet Adapter or the IBM

Dual-port 10Gb-T (copper) Ethernet Adapter, complete the following steps:

1. Read the safety information and installation guidelines, see "Safety" on page vii

2. Turn off the server (see "Turning off the server" on page 22) and all attached

3. Remove the top cover (see "Removing the server top cover" on page 226).

4. Open the adapter retention latch.

5. Carefully grasp the adapter and pull it out of the connector on the system

6. If you are instructed to return the adapter, follow all packaging instructions,

System x3750 M4 Types 8722 and 8733: Installation and Service Guide

and "Installation guidelines" on page 35.

peripheral devices. Disconnect all power cords; then, disconnect all external

cables as necessary to replace the device.

and use any packaging materials for shipping that are supplied to you.

Troubleshooting