IBM System x3750 M4 Installation And Service Manual page 163

- Reset IMM
Select this choice to reset the IMM settings.
– Recovery
Select this choice to view or set the number of POST attempts and configure
start recovery attempts.
- POST attempts
Select this choice to view or set the number of attempts to POST before the
recovery is started.
- System Recovery
Select this choice to view or set the time to start the system recovery
attempt.
v POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
v POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
v Reboot System on NMI
Select this choice to enable or disable restarting the server whenever a
nonmaskable interrupt (NMI) occurs. The default is Enabled.
v Halt On Server Error
Select this choice to prevent the server from booting the operating
system and displaying the POST event viewer when a severe error is
detected during POST.
– Storage
Select this choice to view and manage RAID controller configurations.
– Network
Select this choice to view or configure the network device options, such as
iSCSI, PXE, and network devices. There might be additional configuration
choices for optional network devices that are compliant with UEFI 2.1 and
later.
– Driver Health
Select this choice to view the health of the controllers in the server as
reported by their device drivers.
v Date and Time
Select this choice to set the date and time in the server, in 24-hour format
(hour:minute:second).
This choice is on the full Setup utility menu only.
v Start Options
Select this choice to view the startup sequence or select an option to try and
boot from immediately. Changes in the startup options take effect when you
start the server.
v Boot Manager
Select this choice to view, add, delete, or change the device boot order, boot from
a file, boot from a device, or boot the UEFI shell. This choice is on the full Setup
utility menu only.
v System Event Logs
Select this choice to enter the System Event Manager, where you can view the
POST event log and the system-event log. You can use the arrow keys to move
between pages in the error log. This choice is on the full Setup utility menu only.
Chapter 3. Configuration information and instructions
145