Replacing The 8X1.8-Inch Hot-Swap Drive Backplane Assembly - IBM System x3750 M4 Installation And Service Manual

10. If you are instructed to return the drive backplane, follow all packaging

Replacing the 8x1.8-inch hot-swap drive backplane assembly

This information provides instructions on how to replace the 8x1.8-inch hot-swap
drive backplane assembly.
About this task
To replace the 8x1.8-inch hot-swap drive backplane assembly, complete the
following steps:
Procedure
294
System x3750 M4 Types 8722 and 8733: Installation and Service Guide
8. Disconnect the combination power/configuration cable from the backplane
assembly. If SAS signal cables are attached to the drive backplane, disconnect
them.
9. Lift up the spring release latch slightly while pushing the assembly from the
back and slide the backplane assembly out the front of the server.
8x 1.8-inch
drive backplane
assembly
1.8-inch
filler panel
instructions, and use any packaging materials for shipping that are supplied
to you.
1. Read the safety information that begins on page "Safety" on page vii and
"Installation guidelines" on page 35.
2. Align the drive backplane assembly with the drive-bay slots in which you
want to install the assembly.
8x 1.8-inch
drive backplane
assembly
1.8-inch
filler panel
3. Slide the drive backplane assembly into the slot until it clicks into place.
Release
latch
Drive LEDs