Logging On To The Imm Cli Interface Using Telnet; Logging On To The Imm Cli Interface Using Ssh - IBM System x3750 M4 Installation And Service Manual

What to do next
Note: If you boot to the operating system while in the IMM GUI and the message
"Booting OS or in unsupported OS" is displayed under System Status → System
State, disable Windows 2008 firewall or type the following command in the
Windows 2008 console. This might also affect blue-screen capture features.
netsh firewall set icmpsetting type=8 mode=ENABLE
By default, the icmp packet is blocked by Windows firewall. The IMM GUI will
then change to "OS booted" status after you change the setting as indicated above
in both the Web and CLI interfaces.

Logging on to the IMM CLI interface using telnet

Use this information for instructions on how to log on to the IMM CLI interface
using telnet.
About this task
To log on to the IMM CLI interface using telnet, complete the following steps:
Procedure
1. From the command prompt, type telnet; then, the IP address for the IMM to
2. Type the USERID and PASSWORD for the IMM and press Enter.
3. At the system prompt, type your command.
4. When you are finished, type Exit, to exit the session.

Logging on to the IMM CLI interface using SSH

Use this information for instructions on how to log on to the IMM CLI interface
using SSH.
About this task
To log on to the IMM CLI interface using SSH, complete the following steps:
Procedure
1. Generate an SSH Server private key, see the Integrated Management Module II
2. Make sure that the SSH Server is enabled.
3. From the command prompt, type ssh, then press Enter.
4. Type USERID@IPADDRESS in the command prompt (where the USERID and
5. Type the PASSWORD for the IMM and press Enter.
6. At the system prompt, type your command.
154
System x3750 M4 Types 8722 and 8733: Installation and Service Guide
which you want to log on to and press Enter.
Note: You can type help in the command prompt if you want to see a list of
commands that you can use.
User's Guide at http://www.ibm.com/support/entry/portal/
docdisplay?lndocid=MIGR-5089484 for information on how to generate an SSH
Server private key.
IP ADDRESS is the user ID and IP address for the IMM to which you want to
log on to), then press Enter.
Note: You can type help in the command prompt if you want to see a list of
commands that you can use.