Completing The Installation; Replacing The Dimm Air Baffle - IBM System x3750 M4 Installation And Service Manual

Completing the installation

This information describes the steps for completing the installation after installing
components.
About this task
To complete the installation, complete the following steps:
Procedure
10. Install the server in the rack (see the Rack Installation Instructions that come

Replacing the DIMM air baffle

This information provides instructions on how to replace the DIMM air baffle.
About this task
To install the DIMM air baffle, complete the following steps:
Procedure
1. Read the safety information and installation guidelines, see "Safety" on page vii
2. Align the tabs on the sides of the DIMM air baffle with the slots on the sides of
1. Make sure that the SAS cable guide is closed.
2. If you removed any air baffles or the microprocessor and memory expansion
tray, reinstall them (see "Replacing the DIMM air baffle," "Replacing the
microprocessor and memory expansion tray assembly" on page 131, and
"Replacing the microprocessor air baffle" on page 130).
3. Replace the fan cage assembly, if you removed it (see "Replacing the fan cage
assembly" on page 132).
4. Reconnect the cables (see "Connecting the cables" on page 134).
5. Update the server configuration (see "Updating the server configuration" on
page 135).
6. Reconnect the power cords.
7. If you removed the server cover, replace it (see "Replacing the server top
cover" on page 133).
8. Start the server. Confirm that is starts correctly and recognizes the newly
installed devices, and make sure that no error LEDs are lit.
9. (IBM Business Partners only) Complete the additional steps in "Instructions
for IBM Business Partners" on page 26.
with the server for instructions).
and "Installation guidelines" on page 35.
the chassis wall and lower the DIMM air baffle into the server.
Chapter 2. Installing optional devices
129