Removing And Replacing Tier 2 Crus - IBM System x3750 M4 Installation And Service Manual

Types 8722 and 8733

Hide thumbs Also See for System x3750 M4:

Table of Contents

3. Reconnect the cable to the rear of the operator information panel assembly.

Note: Make sure that cable is installed correctly by using the keys on the

connector and the keys on the cable. Incorrect installation of the cable can

damage the operator information panel.

4. Install the cover (see "Replacing the server top cover" on page 227).

5. Slide the server into the rack.

6. Reconnect the power cords and any cables that you removed.

7. Turn on the peripheral devices and the server.

Removing and replacing Tier 2 CRUs

This information provides instructions for removing and replacing tier 2 CRUs.

You may install a Tier 2 CRU yourself or request IBM to install it, at no additional

charge, under the type of warranty service that is designated for your server.

The illustrations in this document might differ slightly from your hardware.

Operator information

Chapter 6. Removing and replacing components