Removing The Bezel - IBM System x3750 M4 Installation And Service Manual

Types 8722 and 8733

Hide thumbs Also See for System x3750 M4:

Table of Contents

3. Slide the cover toward the front of the server; then, press down on the cover

4. Slide the server back into the rack cabinet until it latches.

5. Reconnect the external cables and power cords.

Removing the bezel

This information provides instructions on how to remove the bezel.

About this task

To remove the bezel, complete the following steps:

1. Read the safety information and installation guidelines, see "Safety" on page vii

2. Turn off the server (see "Turning off the server" on page 22) and all attached

3. Slide the server out of the rack.

4. Remove the screws from the bezel with a Torx screwdriver.

System x3750 M4 Types 8722 and 8733: Installation and Service Guide

release latch until it clicks into place.

and "Installation guidelines" on page 35.

peripheral devices. Disconnect all power cords; then, disconnect all external

cables as necessary to replace the device.

Cover release