Updating The Server Configuration - IBM System x3750 M4 Installation And Service Manual

Types 8722 and 8733

Hide thumbs Also See for System x3750 M4:

Table of Contents

Systems-management

Ethernet connector

You must turn off the server before you connect or disconnect cables.

See the documentation that comes with any external devices for additional cabling

instructions. It might be easier for you to route cables before you connect the

devices to the server.

Updating the server configuration

Use this information to find out how to update the server configuration.

When you start the server for the first time after you add or remove a device, you

might receive a message that the configuration has changed. The Setup utility

starts automatically so that you can save the new configuration settings.

Some optional devices have device drivers that you must install. For information

about installing device drivers, see the documentation that comes with each device.

If the server has an optional RAID adapter and you have installed or removed a

hard disk drive, see the documentation that comes with the RAID adapter for

information about reconfiguring the disk arrays.

The server comes with at least one microprocessor. If more that one microprocessor

is installed, the server can operate as a symmetric multiprocessing (SMP) server.

You might have to upgrade the operating system to support SMP. For more

information, see "Typical operating-system installation" on page 141 and the

operating-system documentation.

For information about configuring the integrated Ethernet controller, see

"Configuring the Ethernet controller" on page 156.

System error

Chapter 2. Installing optional devices

AC power LED (green)

DC power LED (green)

Power supply

error LED (amber)