Installing A Usb Embedded Hypervisor Flash Device - IBM System x3750 M4 Installation And Service Manual

Results
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 129.

Installing a USB embedded hypervisor flash device

This information provides instructions on how to install a USB embedded
hypervisor flash device.
About this task
To install a hypervisor flash device, complete the following steps:
Procedure
1. Read the safety information and installation guidelines, see "Safety" on page vii
2. Turn off the server (see "Turning off the server" on page 22) and all attached
3. Remove the top cover (see "Removing the server top cover" on page 38).
4. Locate the USB (hypervisor) connector on the system board in which you want
5. Make sure that the lockbar on the USB (hypervisor) connector is in the unlock
6. Align the USB flash device with the connector on the system board and push it
7. Slide the lockbar up to the locked position until the lockbar is seated firmly.
and "Installation guidelines" on page 35.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables from the server.
Note: You might have to remove the PCIe riser-card assembly to access the
USB (hypervisor) connectors.
to install the flash device (see "System-board internal connectors" on page 28
for the location of the connectors for the embedded hypervisor USB flash
device).
position (down).
into the connector until it is firmly seated.
Chapter 2. Installing optional devices
111