IBM System x3750 M4 Installation And Service Manual page 132

Types 8722 and 8733

Hide thumbs Also See for System x3750 M4:

Table of Contents

10. Slide the backplane assembly into the backplane bay until it clicks into place.

11. Connect the combination power/configuration cable end to the power and

System x3750 M4 Types 8722 and 8733: Installation and Service Guide

drive backplane

filler panel

configuration connectors on the backplane assembly; then, connect the power

connector on the other end of the cable to the backplane power connector on

the system board. See the following cabling illustration.

Note: You can connect the cables to the backplane before you install the

backplane onto the cage or you can connect the cables after you install the

backplane, if that is easier for you.

Troubleshooting