Installing An Expansion Enclosure On A System-Board Tray; Removing And Replacing Consumable Parts And Tier 1 Crus - IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual

Installing an expansion enclosure on a system-board tray

To install an expansion enclosure on a system-board tray, complete the following
steps.
1. Orient the expansion enclosure above the system-board tray.
2. Lower the expansion enclosure so that the pins at the rear of the enclosure
3. If you disconnected cables when you removed the expansion enclosure,
4. Pivot the expansion enclosure onto the system-board tray until it clicks into
5. Install the system-board tray in the chassis (see "Installing the system-board

Removing and replacing consumable parts and Tier 1 CRUs

Replacement of consumable parts and Tier 1 CRUs is your responsibility. If IBM
installs a consumable part or Tier 1 CRU at your request, you will be charged for
the installation.
Note: The illustrations in this document might differ slightly from your hardware.
132
System x iDataPlex dx360 M2: Problem Determination and Service Guide
slide down into the slots at the rear of the system-board tray.
reconnect them.
place.
tray in a 2U chassis" on page 127).