IBM System x3750 M4 Installation And Service Manual page 86

8. Attach the drive retention clip that you removed from the previous drive to the
9. Align the drive in the drive bay and slide the drive into the CD/DVD drive
Results
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 129.
68
System x3750 M4 Types 8722 and 8733: Installation and Service Guide
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
v Use of controls or adjustments or performance of procedures other than
those specified herein might result in hazardous radiation exposure.
DANGER
Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following.
Laser radiation when open. Do not stare into the beam, do not view
directly with optical instruments, and avoid direct exposure to the beam.
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
`
Appareil A Laser de Classe 1
side of the new drive.
Note: Be sure to align the bend on the drive retention clip tab with the rear
edge of the CD/DVD drive. Your drive might have more mounting holes than
what is shown in the illustration. Adjust the retention clip alignment based on
your drive.
bay until the drive clicks into place.