IBM System x3750 M4 Installation And Service Manual page 164

v User Security
v Save Settings
v Restore Settings
v Load Default Settings
v Exit Setup
146
System x3750 M4 Types 8722 and 8733: Installation and Service Guide
The POST event log contains the most recent error codes and messages that
were generated during POST.
The system-event log contains POST and system management interrupt (SMI)
events and all events that are generated by the baseboard management
controller that is embedded in the integrated management module (IMM).
Important: If the system-error LED on the front of the server is lit but there are
no other error indications, clear the system-event log. Also, after you complete a
repair or correct an error, clear the system-event log to turn off the system-error
LED on the front of the server.
– POST Event Viewer
Select this choice to enter the POST event viewer to view the error messages
in the POST event log.
– System Event Log
Select this choice to view the system-event log.
– Clear System Event Log
Select this choice to clear the system-event log.
Select this choice to set, change, or clear passwords. The full Setup utility menu,
enables all of the options in the User Security option. See "Passwords" on page
147 for more information.
This choice is on the full and limited Setup utility menu.
– Set Power-on Password
Select this choice to set or change a power-on password. See "Power-on
password" on page 147 for more information.
– Clear Power-on Password
Select this choice to clear the power-on password.
– Set Administrator Password
Select this choice to set or change an administrator password. An
administrator password is intended to be used by a system administrator; it
limits access to the full Setup utility menu. If an administrator password is
set, the full Setup utility menu is available only if you type the administrator
password at the password prompt. For more information, see "Administrator
password" on page 149.
– Clear Admin Password
Select this choice to clear the Administrator Password.
Select this choice to save the changes that you have made in the settings. This
choice is on the full Setup utility menu only.
Select this choice to cancel the changes that you have made in the settings and
restore the previous settings. This choice is on the full Setup utility menu only.
Select this choice to cancel the changes that you have made in the settings and
restore the factory settings. This choice is on the full Setup utility menu only.
Select this choice to exit from the Setup utility. If you have not saved the
changes that you have made in the settings, you are asked whether you want to
save the changes or exit without saving them.