IBM System x3750 M4 Installation And Service Manual page 70

Types 8722 and 8733

Hide thumbs Also See for System x3750 M4:

Table of Contents

To install a DIMM, complete the following steps.

Note: These instructions apply to installing DIMMs on the base system board or

the microprocessor and memory expansion tray.

1. Read the safety information and installation guidelines, see "Safety" on page vii

2. Turn off the server (see "Turning off the server" on page 22) and all attached

3. Remove the top cover (see "Removing the server top cover" on page 38).

4. If you are installing DIMMs on the system board, remove the microprocessor

5. Open the retaining clip on each end of the DIMM connector.

System x3750 M4 Types 8722 and 8733: Installation and Service Guide

Microprocessor 3

and "Installation guidelines" on page 35.

peripheral devices. Disconnect all power cords; then, disconnect all external

cables from the server.

and memory expansion tray (see "Removing the microprocessor and memory

expansion tray assembly" on page 305) or DIMM air baffle (see "Removing the

DIMM air baffle" on page 232), whichever one is installed.

Note: To avoid breaking the retaining clips or damaging the DIMM connectors,

open and close the clips gently.

Power supply 2

Microprocessor 4

Troubleshooting