Removing A Pci Riser-Card Assembly - IBM System x3750 M4 Installation And Service Manual

Types 8722 and 8733

Hide thumbs Also See for System x3750 M4:

Table of Contents

5. Slide the server into the rack.

6. Reconnect the external cables; then, reconnect the power cords and turn on the

peripheral devices and the server.

Note: You must wait approximately 10 seconds after you connect the server to

input power before the power-on button becomes active.

7. Start the Setup utility and reset the configuration.

v Set the system date and time.

v Set the power-on password.

v Reconfigure the server.

See "Using the Setup utility" on page 142 for details.

Removing a PCI riser-card assembly

This information provides instructions on how to remove a PCI riser-card

About this task

To remove a PCI riser-card assembly, complete the following steps:

1. Read the safety information and installation guidelines, see "Safety" on page vii

and the "Installation guidelines" on page 35.

2. Turn off the server (see "Turning off the server" on page 22) and all attached

peripheral devices. Disconnect all power cords; then, disconnect all external

cables as necessary to replace the device.

3. Slide the server out of the rack, if installed in a rack.

4. Remove the top cover (see "Removing the server top cover" on page 226).

5. If an adapter is installed in the PCI riser-card assembly, disconnect any cables

that are connected to the adapter.

6. Grasp the front and rear of the PCI riser-card assembly at the blue touch-points

and lift it out of the PCI riser-card slot on the system board.

Chapter 6. Removing and replacing components