Removing And Replacing Consumable And Structural Parts; Removing The Server Top Cover - IBM System x3650 M4 BD Type 5466 Installation And Service Manual

17. Reconnect the external cables; then, reconnect the power cords and turn on
18. Start the Setup utility and reset the configuration.
19. Either update the server with the latest RAID firmware or restore the
20. Update the UUID (see "Updating the Universal Unique Identifier (UUID)" on
21. Update the DMI/SMBIOS (see "Updating the DMI/SMBIOS data" on page

Removing and replacing consumable and structural parts

This section provides information for removing and replacing consumable and
structural parts in the server.
Replacement of consumable parts and structural parts is your responsibility. If IBM
installs a consumable part or structural part at your request, you will be charged
for the installation.
The illustrations in this document might differ slightly from the hardware.

Removing the server top cover

Use this information to remove the server top cover.
About this task
To remove the server top cover, complete the following steps:
Procedure
1. Read the safety information that begins on page "Safety" on page vii and
2. Turn off the server (see "Turning off the server" on page 22) and all attached
3. If the server has been installed in a rack, press the two release latches on the
258
System x3650 M4 BD Type 5466: Installation and Service Guide
the peripheral devices and the server.
v Set the system date and time.
v Set the power-on password.
v Reconfigure the server.
See "Using the Setup utility" on page 91.
pre-existing firmware from a diskette or CD image (see "Updating the
firmware" on page 87).
page 108).
110).
"Installation guidelines" on page 32.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
front of the server and remove the server out of the rack enclosure.