Installing A Usb Embedded Hypervisor Flash Device - IBM System x3300 M4 Installation And Service Manual

Installing a USB embedded hypervisor flash device

To install a hypervisor flash device, complete the following steps:
1. Read the safety information that begins in Safety and "Installation guidelines"
2. Turn off the server (see "Turning off the server" on page 24) and all attached
3. Carefully turn the server on its side so that it is lying flat, with the cover facing
4. Unlock and remove the left-side cover (see "Removing the left-side cover" on
5. Remove the air baffle (see "Removing the air baffle" on page 41).
6. Unlock the retention latch by pushing it down toward the system board.
7. Align the flash device with the USB connector on the system board and push it
on page 36.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables from the server.
up.
Attention: Do not allow the server to fall over.
page 39).
into the USB connector until it is firmly seated.
Chapter 2. Installing optional devices
103