Installing A Usb Embedded Hypervisor Flash Device - IBM System x3550 M3 Type 4254 Installation And User Manual

If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 103.

Installing a USB embedded hypervisor flash device

To install a hypervisor flash device, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see "Removing the cover" on page 52).
4. Align the flash device with the connector on the SAS/SATA RAID riser-card
5. Slide the blue lockbar toward the flash device to the locked position until it is
98
IBM System x3550 M3 Types 4254 and 7944: Installation and User's Guide
on page 44.
assembly and push it into the connector until it is firmly seated.
seated firmly.