Removing A Usb Embedded Hypervisor Flash Device; Installing A Usb Embedded Hypervisor Flash Device - IBM x3250 M3 Problem Determination And Service Manual

Removing a USB embedded hypervisor flash device

To remove a hypervisor flash device, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see "Removing the cover" on page 130).
4. Remove the riser-card assembly (see "Removing the riser-card assembly" on
5. Remove the flash device:
6. If you are instructed to return the flash device, follow all packaging instructions,

Installing a USB embedded hypervisor flash device

To install a hypervisor flash device, complete the following steps:
on page 127.
page 133).
a. Unlock the retention latch on the USB connector by squeezing the two
retention clips toward each other.
b. Open the retention latch.
c. Grasp the flash device and pull to remove it from the connector.
and use any packaging materials for shipping that are supplied to you.
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 127.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see "Removing the cover" on page 130).
4. Remove the riser-card assembly (see "Removing the riser-card assembly" on
page 133).
5. Align the flash device with the USB connector on the system board and push it
into the USB connector until it is firmly seated.
6. Press down on the retention latch to lock the flash device into the USB
connector.
Chapter 5. Removing and replacing server components
165