Servicing The Front Indicator Module (Fru) - Oracle X7-8 Service Manual

Servicing the Front Indicator Module (FRU)

Reset the Oracle ILOM SP clock using the Oracle ILOM CLI or the web interface.
■
Refer to the Oracle Integrated Lights Out Manager (ILOM) 4.0 Documentation Library at
https://www.oracle.com/goto/ilom/docs.
Use the BIOS Setup Utility to reprogram the host clock.
■
Refer to the Oracle X7 Series Servers Administration Guide at
goto/x86admindiag/docs.
Note -
the Network Time Protocol (NTP), the Oracle ILOM SP clock will be reset as soon as the
server is powered on and connected to the network; otherwise, proceed to the next step.
Related Information
"Install an SMOD" on page 201
■
Servicing the Front Indicator Module (FRU)
This section describes how to service the server front indicator module (FIM). The FIM is
located at the front of the server. The following topics and procedures provide information to
assist you when removing and installing the FIM:
"Remove the FIM" on page 227
■
"Install the FIM" on page 228
■
The FIM is a field-replaceable unit (FRU). For more information about FRUs, see
Parts Breakdown" on page 22
serviceability, locations, and designations, see
Caution -
personnel.
Caution -
electrostatic discharge. This sensitivity can cause the components to fail. To avoid damage,
ensure that you follow antistatic practices as described in
Prevention Measures" on page
226 Oracle Server X7-8 Service Manual • April 2018
If the service processor is configured to synchronize with a network time server using
and
The FIM should be removed and replaced only by authorized Oracle Service
These procedures require that you handle components that are sensitive to
97.
"Field-Replaceable Units" on page
"Replaceable Components" on page
"Electrostatic Discharge and Static
https://www.oracle.com/
"Illustrated
25. For component
22.