Oracle X7-8 Service Manual page 105

and their subcomponents without removing the power cords. Oracle ILOM remains available in
warm service mode.
For more information about component serviceability, see
Requirements" on page
Loss of service or component damage. Do not replace any components except for
Caution -
CMODs and internal CMOD subcomponents while the server is in warm service mode.
Data Loss. Do not remove more than one fan module from a column while the
Caution -
system is in Main power mode. This action removes power from the CMODs and causes an
immediate shutdown. On an eight-CMOD system, this applies to all fan modules. On a four-
CMOD system, this applies to the fan modules in the left-hand fan frame.
Note - This procedure is performed locally and requires physical access to the server front
panel.
Log in to the SP Oracle ILOM CLI.
1.
Log in as a user with root or administrator privileges. For example, open an SSH session, and at
the command line type:
ipaddress
ssh root@
Where ipaddress is the IP address of the server SP.
For more information, see
The Oracle ILOM CLI prompt appears: ->
2. Power off the server gracefully to Standby power mode.
At the prompt, type the following command:
->
stop /System
3. To turn on the Locate Button/LED indicator, type the following command.
->
set /System/ locator_indicator=on
To turn off the Locator indicator, type:
Note -
Once at the service location, press the Locate Button/LED button to deactivate
4.
the indicator.
For more information, see
Prepare the Server for Warm Service (Oracle ILOM CLI)
24.
"Using Oracle ILOM" in Oracle Server X7-8 Installation
set /System/ locator_indicator=off
"Control the Locate Button/LED Locally" on page
"Component Serviceability
.
121.
Preparing for Service
Guide.
105