Servicing System Module (SMOD) Components (FRU)
Servicing System Module (SMOD) Components (FRU)
This section describes how to service System Modules (SMODs) and SMOD components.
Two SMODs are located at the back of the server. The following topics and procedures provide
information to assist you when removing and installing SMODs and SMOD components:
"SMOD Population Rules" on page 198
■
"Remove an SMOD" on page 199
■
"Install an SMOD" on page 201
■
"Servicing the Host Bus Adapter (HBA) Card (FRU)" on page 204
■
"Servicing the Energy Storage Module and Cables (CRU)" on page 211
■
"Servicing Internal USB Flash Drives (FRU)" on page 218
■
"Servicing the System Battery (CRU)" on page 221
■
SMODs are field-replaceable units (FRUs). A customer can remove and insert SMODs
to access internal components that are designated CRUs. For more information
about FRUs, see
Units" on page
Components" on page
Caution -
personnel.
Caution -
electrostatic discharge. This sensitivity can cause the components to fail. To avoid damage,
ensure that you follow antistatic practices as described in
Prevention Measures" on page
SMOD Population Rules
The Oracle Server X7-8 supports two installed SMODs. Both SMOD0 System A and SMOD1
System B are accessible from the back panel.
See
"System Module (SMOD) Overview" on page
198
Oracle Server X7-8 Service Manual • April 2018
"Illustrated Parts Breakdown" on page 22
25. For component serviceability, locations, and designations, see
22. See
"System Module (SMOD) Overview" on page
SMODs should be removed and replaced only by authorized Oracle Service
These procedures require that you handle components that are sensitive to
97.
and
"Field-Replaceable
"Electrostatic Discharge and Static
32.
"Replaceable
32.