Oracle X7-8 Service Manual page 267

ii Log in to the System A Oracle ILOM command-line interface (CLI),
and type the following command at the Oracle ILOM prompt:
-> show /SP/Policy ENABLE_8_SOCKET_MODE
/SP/policy
Properties:
ENABLE_8_SOCKET_MODE = disabled
System A or System B Oracle ILOM Diag shell using hwdiag commands
■
a. Display the current system configuration using the hwdiag command.
The hwdiag commands are accessed from the Oracle ILOM Diag shell. For
information about the Diag shell and how to use the hwdiag commands, see
"Troubleshooting Using Diagnostic Tools" on page
Enter the Oracle ILOM Diag shell. From the Oracle ILOM command-
i
line interface (CLI), type:
-> start /SP/diag/shell
Are you sure you want to start /SP/diag/shell (y/n) ? y
ii Display system summary information. Type:
diag> hwdiag system summary
The system returns summary information. For example, for a server configured
in single 4-socket server mode, output similar to the following is displayed:
diag> hwdiag system summary
HWdiag (Diag Shell) - Build Number 121981 (Oct 17 2017, 16:37:05)
This is a X7-8A.
Platform ORACLE SERVER X7-8
ILOM Firmware Date: Tue Oct 17 16:51:34 PDT 2017, Version: 4.0.2.0
(r121981)
SP Pilot4 Revision: A2
CPLD SMOD0 Version - 38.28
CMOD0 Version - 38.28
CMOD1 Version - 38.28
CMOD2 Version - 38.28
CMOD3 Version - 38.28
BIOS Version - 47020200
Current Date/Time: Oct 25 2017, 10:08:53
Verify the Current Socket Mode Configuration
56.
Configuring the System Socket Modes 267