Pci Devices Subsystem - Oracle X7-8 Service Manual

I/O Subsystem
The server input/ouput I/O subsystem consists of the following:
8 or 16 PCIe Gen3 IO slots (up to eight 16-lane and eight 8-lane)
■
Two 10/100/1000 GbE Network Ethernet ports, one SER MGT port each in SMOD0 and
■
SMOD1
4 USB 3.0 ports (2 external, one each in SMOD0 and SMOD1, 2 internal, one each in
■
SMOD0 and SMOD1)
Internal USB ports are not used.
Note -

PCI Devices Subsystem

Use the Oracle Integrated Lights Out Manager (ILOM) PCI Devices page to view inventory
properties for the PCIe add-in cards and the built-in devices that are detected on your server.
To view the inventory properties for the devices shown on the PCI Devices page, follow these
steps:
1. Click the link at the top of the page for the appropriate PCI device.
2. View the inventory properties appearing in the table. If applicable, mouse-over the Details
column to view additional device properties.
The server PCI devices subsystem consists of the following components:
Installed add-in cards and devices: PCI Card optional component
■
On-board devices: Ethernet Controller NET0-3 (Ethernet NIC 1-4)
■
On-board devices: Internal HBAs (SAS controllers) in SMODs
■
Dual PCIe Card Carrier (DPCC)
In the following figure, callout 1 shows the location of the dual PCIe card carrier (DPCC) bays.
The eight DPCCs are directly accessible from the server back panel and are located below the
SMOD. Each DPCC holds one or two PCIe cards.
Troubleshooting Server Subsystems
Troubleshooting and Diagnostics 89