Oracle X7-8 Service Manual page 108

Prepare the Server for Cold Service (Oracle ILOM CLI)
server is completely powered off and AC cords have been removed from the back panel AC
power block.
For more information about component serviceability, see
Requirements" on page
This procedure is performed locally and requires physical access to the server front and back
panels.
1. Log in to the SP Oracle ILOM CLI.
Log in as a user with root or administrator privileges. For example, open an SSH session, and at
the command line type:
ssh root@
Where ipaddress is the IP address of the server SP.
For more information, see
The Oracle ILOM CLI prompt appears: ->
2. To turn on the Locate Button/LED indicator, type the following command.
->
set /System/ locator_indicator=on
Note -
3. Power off the server gracefully to Standby power mode.
At the prompt, type the following command:
->
stop /System
4. Once at the service location, press the Locate Button/LED button to deactivate
the indicator.
For more information, see
Set up an ESD-safe space at the service location.
5.
Set up a space where you can place components. See
Prevention Measures" on page
6. Disconnect the four server power cords from the AC power block.
Caution -
in an immediate shut down of the server. Do not remove the power cord if the server is in Main
power mode. Power off the server to Standby power mode first.
108 Oracle Server X7-8 Service Manual • April 2018
24.
ipaddress
"Using Oracle ILOM" in Oracle Server X7-8 Installation
To turn off the Locator indicator, type:
"Control the Locate Button/LED Locally" on page
97.
Data loss. Removing the power cords when the server is in Main power mode results
"Component Serviceability
set /System/ locator_indicator=off
"Electrostatic Discharge and Static
Guide.
.
121.