Oracle X7-8 Service Manual page 225

To install the battery, set it in the holder and push it in until the battery snaps into place.
If disconnected during battery removal, reconnect the auxiliary signal cable to the disk
Note -
backplane and the SAS cables to the Internal HBA.
8. Ensure that the battery is properly seated in its holder and the polarity is correct.
9. Install the SMOD.
See "Install an SMOD" on page
10. Repeat these steps for another SMOD as required.
11. Prepare the server for operation.
Verify that the power supply AC OK LEDs are lit.
See "Returning the Server to Operation" on page
12. If necessary, once the server is operational, access the BIOS Setup Utility to set
the clock.
See "Setting Up BIOS Configuration Parameters" on page
If the service processor is not configured to use NTP, you must do one of the
13.
following:
201.
245.
Install the System Battery
279.
Servicing Components 225