Oracle X7-8 Service Manual page 273

The hwdiag commands are accessed from the Oracle ILOM Diag shell. For information about
the Diag shell and how to use the hwdiag commands, see
Tools" on page 56.
Enter the Oracle ILOM Diag shell. From the Oracle ILOM command-line interface (CLI), type:
-> start /SP/diag/shell
Are you sure you want to start /SP/diag/shell (y/n) ? y
3. Confirm that CMODs 0-3 match CMODs 4-7 to ensure all eight CMODs have
identical processors installed.
a. At the Diag shell prompt, type:
diag> hwdiag cpu info all
HWdiag (Diag Shell) - Build Number 121981 (Oct 17 2017, 16:37:05)
Current Date/Time: Oct 25 2017, 10:15:53
This is a X7-8A.
CPU0
CPUID: 50654 (H Stepping)
RAS Availability: Advanced RAS
S-spec/QDF Number: QMRV
Thermal Design Power: 150 Watts
Number of SKU enabled cores: 24
Number of cores: 24
Number of threads: 2
Current cores enabled: 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
21 22 23
Current threads enabled: 0 1
DIMM Voltage Setting: 1.20V
Link 0 status:
Link 1 status:
Enabled
Link Rate Setting 10.4 GT/s
Link State Initialization done
Type 0
Active 0
TxWidth 20
RxWidth 20
Link Clock Speed Full Speed
Tx Lanes dropped none
Tx Lanes disabled none
Rx Lanes dropped none
Rx Lanes disabled none
Enabled
Link Rate Setting 10.4 GT/s
Link State Initialization done
Type 0
Active 0
Verify the CMOD Configuration
"Troubleshooting Using Diagnostic
Configuring the System Socket Modes 273