Oracle X7-8 Service Manual page 219

1. Prepare the server for cold service.
This is a cold-service component. Power down the system and disconnect the AC power cables
from the server before performing this procedure.
See "Preparing the Server for Component Replacement" on page
Remove SMOD0 or SMOD1.
2.
See "Remove an SMOD" on page
3. Set the SMOD on a flat surface with the front side facing toward you.
4. Close the SMOD handles.
5. Rotate the SMOD 180 degrees so the back (connector) side is facing toward you.
6. Turn the SMOD upside down and locate the HBA card.
The connector (back) side of the SMOD should still be facing you.
Note -
7. To remove the USB drive, pull it out of its slot.
The USB flash drive slot is located inside SMOD0 or SMOD1 next to the HBA card.
199.
Remove the Internal USB Flash Drive
100.
Servicing Components 219