Oracle X7-8 Service Manual page 220

Install the Internal USB Drive
Related Information
"Install an SMOD" on page 201
■
Install the Internal USB Drive
Perform this procedure to access and install the internal USB flash drive when instructed by
service personnel. This is an internal component accessible from the back of the server by
removing SMOD0 and SMOD1.
Prepare the server for cold service.
1.
This is a cold-service component. Power down the system and disconnect the AC power cables
from the server before performing this procedure.
See "Preparing the Server for Component Replacement" on page
Remove the SMOD.
2.
See "Remove an SMOD" on page
3. Set the SMOD on a flat surface with the front side facing toward you.
4. Close the SMOD handles.
5. Rotate the SMOD 180 degrees so the back (connector) side is facing toward you.
6. Turn the SMOD upside down and locate the HBA card.
Note -
220 Oracle Server X7-8 Service Manual • April 2018
The connector (back) side of the SMOD should still be facing you.
199.
100.