Oracle X7-8 Service Manual page 72

Troubleshooting Using Status Indicators
System Condition
SP is booted and ready to use. Host is off.
SP is running. Host is booting.
SP and host are running. This is the normal operating state of the
system.
Locate Button/LED Indicator On
Locate Button/LEDs are white combination button/indicators that are located on both the front
FIM and back panel at SMOD0 and SMOD1. To deactivate (or activate) the Locate Button/
LED, press and release the Locate button. When the Locate Button/LED is on, the LED blinks
at the fast blink rate. You can turn the Locate Button/LED off remotely from Oracle ILOM,
or by pressing a Locate button on the chassis. The buttons on the server front and back allow
you to manage System A (SMOD0) and System B (SMOD1) Locate Buttons/LED indicators
locally.
Turn a Locate Button/LED on remotely from Oracle ILOM to locate the server in a rack.
■
Typically, a server readied for service is placed in Standby power mode and the SMOD0 or
SMOD1 Locate indicator is lit.
Press the SMOD0 or SMOD1 Locate Button/LED button to prove physical presence. Some
■
service procedures require you to prove physical presence by pressing the Locate Button/
LED button.
The following figure shows two Locate Button/LEDs for System A [callout 1] and System B
[callout 2] on the server front panel FIM.
72 Oracle Server X7-8 Service Manual • April 2018
SP Indicator
Steady On
Steady On
Steady On
Power OK Indicator
Blinks at single blink rate (quick
flash every 3 seconds)
Blinks at fast rate
Steady On