Table of Contents
Advertisement
6.
Turn the SMOD upside down and locate the HBA.
The HBA card is located inside the SMOD.
The connector (back) side of the SMOD should still be facing you.
Note -
Disconnect the SAS cable from the HBA port [1].
7.
8.
Disconnect the SAS cable from the drive backplane [2].
Carefully route the SAS cable away from the guide.
9.
Remove the SAS cable from the SMOD.
10.
Connect the replacement Mini-SAS4I cable end labeled "TO DBP" to the drive
11.
backplane.
12.
Route the replacement SAS cable from the drive backplane to the HBA card
connector.
13.
Ensure that the are routed under the support bracket.
14.
Connect the replacement Mini-SAS4I cable end labeled "TO HBA" to the HBA
card connector.
Replace the SAS Cable
Servicing Components
217
Advertisement
Table of Contents
Troubleshooting
