Power On The Server - Oracle X7-8 Service Manual

Power On the Server

7. Verify that none of the server Fault-Service Required indicators on externally
facing indicator panels are lit.
Note -
indicators. For details, see
Power on the server.
8.
Power On the Server
When AC power is applied to the server power inlets, the System A or System B server boots
into Standby power mode. For information, see
State Indicators" on page
Use the following procedure to reapply Main power for System A or System B server
components.
Ensure that the server is in Standby power mode.
1.
2. To power on the server, do one of the following:
From the front of the server, press and immediately release the Power
■
button on the server front panel.
From the Oracle ILOM web interface Summary Information page, click
■
State Turn On
From the Oracle ILOM command-line interface (CLI), type:
■
->
Note -
complete.
When the server is powered on and the power-on self-test (POST) code checkpoint tests have
completed, the System B green System OK LED status indicator on the front panel of the server
lights and remains lit.
Verify that the two power supply AC OK LEDs are lit.
246 Oracle Server X7-8 Service Manual • April 2018
After replacing some components, you must clear the fault in Oracle ILOM to clear fault
"Clear Hardware Fault Messages (Oracle ILOM)" on page
71.
button.
start /System
When the server powers on, the power-on self-test (POST) can take several minutes to
"Server Boot Process and Normal Operating
51.
Power