Figure 11-2 Trigger Configuration Menu Tree - Keithley SourceMeter 2400 User Manual

11-10 Triggering
NOTE
For the Model 2430 Pulse Mode, an output trigger can only occur after the mea-
sure action. Therefore, the output trigger settings for the source and delay
actions are ignored.
– DELAY — Specify the time delay (in seconds) for the trigger delay.
NOTE
For the Model 2430 Pulse Mode, trigger delay is not used. Therefore, the trigger
delay setting is ignored.
COUNT — Specify the trigger count.
–
• HALT — Use to return the SourceMeter to the idle state. HALT does not turn off
the output. The programmed source level will still be available at the OUTPUT ter-
minals. The following actions will take the SourceMeter out of idle:
– Turn the output off and then on again.
– Re-select the arm or trigger event.
– Exit from the menu structure, and then re-enter it by pressing CONFIG and
then TRIG.
Figure 11-2
Trigger configuration menu tree
ARM
LAYER
ARM
ARM IN COUNT
OUT
LINE EVENTS
IMMEDIATE
GPIB TIMER MANUAL
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2400 Series SourceMeter
CONFIG
TRIG
TRIG
LAYER
TRIGGER
TRIGGER
IN OUT
TRIGGER
IMMEDIATE LINE EVENTS
LINK
↓ ↑ ↑↓
TLINK STEST STEST STEST
®
User's Manual
HALT
DELAY COUNT