Configuring Triggering - Keithley SourceMeter 2400 User Manual

11-8 Triggering
Configuring triggering
Trigger configuration menu
Press CONFIG and then TRIG to display the trigger configuration menu, which is outlined
below and shown in
while dashes and slashes indicate options. Use
check and/or change trigger options. See also
for more information on programming the various trigger parameters.
• ARM LAYER — Use this menu item to configure the arm layer of the trigger
model:
– ARM IN — Use to select the detection event for the arm layer:
/ IMMEDIATE — Event detection occurs immediately.
/ GPIB — Event detection occurs when a bus trigger (GET or *TRG) is
received.
/ TIMER — Initially, event detection is satisfied immediately. Subsequent
event detection occurs after the timer interval elapses. After selecting this
arm event, you will be prompted to specify the timer interval (in seconds).
/ MANUAL — Event detection occurs when the TRIG key is pressed.
/ TLINK — After selecting this arm event, you will be prompted to select
the input line for the Trigger Link and the state of the event detection
bypass. With ONCE selected, operation will loop around the arm event
detector on each new pass through the trigger model. With NEVER
selected, operation always waits for the input trigger.
↓
/ STEST — Event detection occurs when the SOT line of the Digital I/O
port is pulsed low. After selecting this arm event, you will be prompted to
select the state of the event detection bypass. With ONCE selected, opera-
tion will loop around the arm event detector on each new pass through the
trigger model. With NEVER selected, operation always waits for the input
trigger.
↑
/ STEST — Event detection occurs when the SOT line of the Digital I/O
port is pulsed high. After selecting this arm event, you will be prompted to
select the state of the event detection bypass.
↑↓
/
port is pulsed either high or low. After selecting this arm event, you will
be prompted to select the state of the event detection bypass.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2400 Series SourceMeter
Figure 11-2. Note that bullets indicate the primary items of the menu,
Section 1,
"Front panel trigger example," page
STEST — Event detection occurs when the SOT line of the Digital I/O
®
User's Manual
"Rules to navigate menus," to
11-20,