Step 7: Turn Output On - Keithley SourceMeter 2400 User Manual

5-14 Pulse Mode Operation (Model 2430 only)

Step 7: Turn output on.

Turn the output on by pressing the TRIG key or the ON/OFF OUTPUT key. The OUTPUT
indicator will be on whenever a pulse is being sourced. During each pulse off-time, the
output will be off (indicator off).
If configured to output a finite number of pulses, the output will disable after the last pulse
is sourced. While sourcing pulses, you can disable the output at any time by pressing the
ON/OFF OUTPUT key.
Pulse-ohms measurements
NOTE
Ohms source readback cannot be used for the Pulse Mode. Make sure that the
source is not in compliance when taking pulse-ohms readings.
"Ohms source
Auto and Manual pulse-ohms measurements
While in the Pulse Mode, the Model 2430 can perform auto or manual ohms measure-
ments. After selecting and configuring the Pulse Mode as explained in this section, per-
form the "Auto ohms
procedure in Section
For remote operation, see
basic ohms measurements.
Offset-compensated pulse-ohms measurements
While in the Pulse Mode, offset-compensated ohms is available as a math function
(FCTN). After selecting and configuring the Pulse Mode as explained in this section, refer
to Section 8, "Math
For remote operation, see
form offset-compensated ohms.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2400 Series SourceMeter
readback."
measurements" procedure or the "Manual ohms
4.
Section 4, "Remote ohms programming," for the commands for
operations," to perform offset-compensated ohms measurements.
Section 8, "Remote math operations," for the commands to per-
®
User's Manual
Section 4 covers
measurements"