Resistance:mode <Name> - Keithley SourceMeter 2400 User Manual

®
2400 Series SourceMeter User's Manual
RESistance:MODE <name>
[:SENSe[1]]:RESistance:MODE <name>
Parameters
<name> =
Query
:MODE?
Description
This command is used to select the ohms measurement mode. With
MANual ohms selected, the user must configure the source and measure
aspects of the operation. When the ohms function is selected, the ohms
reading is simply the result of the V/I calculation.
Range changes cannot be made in manual ohms.
With AUTO ohms selected, the SourceMeter will be configured to
Source I Measure V when the ohms function is selected. The current
source value and voltage measurement range used depends on the ohms
measurement range that is selected.
See
ohms.
RESistance:OCOMpensated <b>
[:SENSe[1]]:RESistance:OCOMpensated <b>
Parameters
<b> =
Query :OCOMpensated?
Description This command is used to enable or disable offset-compensated ohms.
When using the auto ohms measurement mode, the current source level
is automatically set. When using the manual ohms measurement mode,
you must set the source (V or I) output level.
See
set-compensated ohms measurements.
NOTE Offset-compensated ohms will disable when the :MEASure? command (for the
resistance function) or the :CONFigure:RESistance command is sent.
NOTE For the Model 2430 Pulse Mode, offset-compensated ohms cannot be enabled
using this command. Sending this command results in error +831.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
SCPI Command Reference
Select ohms measurement mode
MANual Manual ohms mode
AUTO Auto ohms mode
Query ohms mode
Section 4, "Ohms Measurements," for details on manual and auto
Control offset-compensated ohms
1 or ON Enable offset compensation
0 or OFF Disable offset compensation
Query state of offset compensation
Section 4, "Offset-compensated ohms," for details on making off-
18-63