Table - Keithley SourceMeter 2400 User Manual

3-4 Basic Source-Measure Operation
The full range of operation is explained in
ating boundaries."
NOTE Output transient recovery — The time required for the V-source to recover to its
original value (within 0.1% plus load regulation errors) after a step change in
load current is <250µsec. This does not include the response time of autorang-
ing or the second order effects on loads that are not purely resistive.
Load regulation — The voltage specification for V-source mode load changes is
0.01% +1mV. This means that on the 200mV range, the load current can be
changed from zero to full scale with less than 1.02mV of error. Calculation:
error = (0.01% x 0.2V) + 1mV = 1.02mV
Assuming a 0 to 1A change in current, the output impedance equates to 1.02m Ω
(1.02mV/1A = 1.02m Ω ). This level can only be achieved using 4-wire remote
sensing.

Table 3-1

Source-measure capabilities
2400
Range Source
200mV
±210mV
2V ±2.1V
20V ±21V
200V ±210V
1µA ±1.05µA
10µA ±10.5µA
100µA ±105µA
1mA ±1.05mA
10mA ±10.5mA
100mA ±105mA
1A ±1.05A
Max Power = 22W
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2400 Series SourceMeter
Section 6, "Overheating
2410
Measure Range Source Measure
200mV
±211mV ±210mV ±211mV
±2.11V 2V ±2.1V ±2.11V
±21.1V 20V ±21V ±21.1V
±211V 1000V ±1.1kV ±1.1kV
±1.055µA 1µA ±1.05µA ±1.055µA
±10.55µA 10µA ±10.5µA ±10.55µA
±105.5µA 100µA ±105µA ±105.5µA
±1.055mA 1mA ±1.05mA ±1.055mA
±10.55mA 20mA ±21mA ±21.1mA
±105.5mA 100mA ±105mA ±105.5mA
±1.055A 1A ±1.05A ±1.055A
Max Power = 22W
®
User's Manual
protection" and "Oper-