Saving Multiple Source Memory Sweeps - Keithley SourceMeter 2400 User Manual

10-8 Sweep Operation
Saving source memory setups
Perform the following steps to save source memory setups:
1. Configure the SourceMeter for the desired source, measure, and/or math expres-
sion operation.
2. Press MENU to display the MAIN MENU:
• Select SAVESETUP.
• Select SOURCE MEMORY.
• Select SAVE.
• Use the
tion, and press ENTER.
• Use the EXIT key to back out of the menu structure.
3. Configure the SourceMeter for the next point in the sweep, and repeat Step 2 to
save that setup in the next memory location.
4. Repeat Step 3 for all points in the sweep.
Restoring source memory setups
In addition to automatically sweeping through source memory locations (see
and running a sweep" later in this section), you can also recall them individually as
follows:
1. Press MENU to display the MAIN MENU.
2. Select SAVESETUP, then press ENTER.
3. Choose SOURCE MEMORY, then press ENTER.
4. Select RESTORE, then press ENTER.
5. Select the source memory location to restore (1-100), then press ENTER.

Saving multiple source memory sweeps

If desired, you can save multiple source memory sweeps in the 100 memory locations. For
example, you could save setups in locations 1 through 4 for one sweep, and other setups in
any other range of memory locations such as locations 50 through 58. To select which
sweep to execute, simply select two settings: (1) the sweep start location, and (2) the num-
ber of sweep points. (See
Saved source memory configurations
Table 10-2 summarizes the configurations that are saved at each source memory location
along with the equivalent remote command. See
remote commands. The SCPI command reference tables,
also list source memory parameters.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2400 Series SourceMeter
and keys, and the cursor keys to display the desired memory loca-
"Performing a source memory sweep" later in this section.)
Section 18
Table 18-1
®
User's Manual
"Configuring
for more details on these
through Table 18-11,