Source2 <Name> - Keithley SourceMeter 2400 User Manual

®
2400 Series SourceMeter User's Manual
Example reading string
The example ASCII reading string shown in
surement of a 10kΩ resistor, with the SourceMeter configured to Source
I Measure V. The voltage reading is the voltage measurement
(1.000236V), the current reading is the current source value (100Ω, and
the operation was performed 72.826 seconds after the SourceMeter was
turned on (or after timestamp was reset). The status reading of 48,132
indicates that bits 2, 10, 11, 12, 13, and 15 of the status word are set.
SOURce2 <name>
:FORMat:SOURce2 <name>
Parameters
<name> =
Query
:SOURce2?
Description
This command controls the response format for all
CALC2:XXXX:SOUR2 and SOUR2:TTL queries in a manner similar
to formats set by the FORM:SREG command. See
systems," page
details.
CALC data elements
CALCulate <item list>
:FORMat:ELEMents:CALCulate <item list>
Parameters <item list> = CALC
NOTE Each item in the list must be separated by a comma (for example, :CALCulate
CALC,TIME,STAT).
Query
:CALCulate?
Description
This command allows you to retrieve timestamp and status information
with the CALC1:DATA? And CALC2:DATA? queries. It also allows
you to retrieve timestamp and status information when TRACe:FEED is
set to CALC1 or CALC2. See
complete description of CALC1 and CALC2. See
page
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
SCPI Command Reference
Set SOUR2 and TTL response formats
ASCii ASCII format
HEXadecimal Hexadecimal format
OCTal Octal format
BINary Binary format
Query response format
18-24, and "SOURce subsystem," page
Set CALC data elements
Include CALC1 or CALC2 data
TIME Include timestamp
STATus Include status information
Query CALC data element list
"Calculate subsystems," page
18-51, for a description of TIME and STATus information.
18-55
Figure 18-1 shows a mea-
"Calculate sub-
18-72, for
18-24, for a
"Data elements,"