Points <Nrf> - Keithley SourceMeter 2400 User Manual

®
2400 Series SourceMeter User's Manual
ROUTe:TERMinals
CALCulate1:STATe
CALCulate1:MATH[:EXPRession]:NAME
CALCulate2:FEED
CALCulate2:NULL:OFFSet
CALCulate2:NULL:STATe
CALCulate2:LIMit[1]:STATe
CALCulate2:LIMit[1]:COMPliance:FAIL
CALCulate2:LIMit[1]:COMPliance:SOURce2
CALCulate2:LIMitX:STATe
CALCulate2:LIMitX:UPPer[:DATA]
CALCulate2:LIMitX:UPPer:SOURce2
CALCulate2:LIMitX:LOWer[:DATA]
CALCulate2:LIMitX:LOWer:SOURce2
CALCulate2:LIMitX:PASS:SOURce2
CALCulate2:CLIMits:PASS:SOURce2
CALCulate2:CLIMits:PASS:SMLocation
TRIGger:DELay (Model 2430 in DC Mode)
Contact check commands
After saving the desired setups in consecutive memory locations (unless
branching, see CALC2:CLIM:PASS:SML), use the :POINts command
to specify how many sweep points to perform and the :STARt command
to specify where to start from.
POINts <NRf>
:SOURCe:MEMory:POINts <NRf>
Parameters
<NRf> =
Description
This command is used to specify the number of points for the sweep.
For example, if you saved setups in memory locations 1 through 12 for a
sweep, specify a 12-point sweep using this command.
STARt <NRf>
:SOURCe:MEMory:STARt <NRf>
Parameters
<NRf> =
Description
This command is used to set the starting location of a Source Memory
Sweep. For example, for setups saved in memory locations 98 through
5, specify a starting location of 98.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
SCPI Command Reference
where: X = 2, 3 and 5 through 12
(Appendix F)
Specify number of sweep points to
execute
1 to 100 Number of sweep points
Select Source Memory Sweep start
location
1 to 100 Specify memory location
18-95