YASKAWA VIPA System SLIO Manual page 315

VIPA System SLIO
Data type
CFG
Bit Name
0 reserved
1
Write Protect
2 reserved
3 Phase 1
4 Phase 2
5 Phase 3
6 Data type
7 Byteorder
*) Access to the 'Write Protect' parameter is only possible via the Web server of the head module (not via GSD or GSDML).
HB300 | SM-AIO | | en | 17-05
– As long as no parameters have been sent from the head station to
the module after a power cycle, default values are transmitted by the
module during a read access and not the parameters stored in the
module.
– After transferring the parameters to the module the status bits are
reset and the measurement is interrupted for a short time!
– Please note when at least one phase is de-activated, the parameters
PF_MIN and VRMS_MIN are ignored and set to "0".
– On error in the parametrization the MF LED blinks and you receive an
error message.
Ä 'Data type' on page 310
Description
Write protection bit for parameterization via Web server
*)
0: Write Protect de-activated
1: Write Protect activated
Please see the following note!
Measurement phase L1
0: Measurement is activated
1: Measurement is de-activated
Measurement phase L2
0: Measurement is activated
1: Measurement is de-activated
Measurement phase L3
0: Measurement is activated
1: Measurement is de-activated
Data type of the measured values in the user data
0: Integer (INT)
1: 32bit floating point (FLOAT) DIN IEEE 754
Data type of the measured values in the user data
0: Big-Endian: Byte order: high byte, low byte
1: Little-Endian: Byte order: low byte, high byte
031-1PA00 - AI1x 3Ph 230/400V 1A > Parameter data
Ä 'Status communication' on page 319
Analog Input
Default
0
1 *)
0
0
0
0
0
0
315