YASKAWA VIPA System SLIO Manual page 283

VIPA System SLIO
DIAG_EN Diagnostics
WIBRK_EN Wire break
recognition
TEMPCNF Temperature
system
SUPR Interference fre-
quency suppression
CHxFN Function number
channel x
HB300 | SM-AIO | | en | 17-05
Byte Bit 7 ... 0
0 n Diagnostic interrupt
– 00h: disabled
– 40h: enabled
Here you can enable respectively disable the diagnostic interrupt.
n
Byte Bit 7 ... 0
0 n Bit 0: Wire break recognition channel 0 (1: on)
n Bit 1: Wire break recognition channel 1 (1: on)
n Bit 7 ... 2: reserved
Byte Bit 7 ... 0
0 Bit 0, 1: Temperature system
n
– 00: °C
– 01: °F
– 10: K
n Bit 7 ... 2: reserved
Byte Bit 7 ... 0
0 n Bit 0, 1: Interference frequency suppression
– 01: 60Hz
– 10: 50Hz
n Bit 7 ... 2: reserved
In the following there are the measuring ranges with corresponding function number
listed, which were supported by the analog module. With FFh the corresponding channel
is deactivated.
031-1LB90 - AI 2x16Bit TC > Parameter data
Analog Input
283