YASKAWA VIPA System SLIO Manual page 183

VIPA System SLIO
MEAS Measurement
method
FILT Filter selection
DFCT Dynamic Filter
Change Time
Dynamic filter delta
RO Rated output
HB300 | SM-AIO | | en | 17-05
n During self-calibration, the CAL LED is on an the measured value is frozen.
n 00h de-activates the calibration.
Byte Bit 7 ... 0
0 Measurement method
n
– 23h: 6 wire measurement
– 25h: 4 wire measurement
– FFh: de-activated
n Here you can choose between 4 and 6 wire measurement respectively disable the
measurement.
Byte Bit 7 ... 0
0 Filter selection
n
– 00h: Filter de-activated
– 01h: Activate dynamic IIR filter
– 02h: IIR1
– 03h: IIR2
– 04h: IIR3
– 05h: IIR4
– 06h: IIR5
– 07h: IIR6
– 08h: IIR7
– 09h: IIR8
– 0Ah: FIR 50Hz
– 0Bh: FIR 60Hz
Filter functions
n FIR 50/60 Hz
– Suppression of mains frequency interference
n Dynamic IIR filter
– automatic selection
– Filter selection dependent on the current weight change
n Static IIR filter
– De-activation respectively fix setting of a filter level (IIR1...IIR8)
Byte Bit 7 ... 0
0...1 Sampling rate for filter change-over in ms
n Here you can specify the time for re-evaluation for the filter change-over in ms.
Byte Bit 7 ... 0
0...1 Limit value for filter change-over
n Here you can specify the limit value for the filter change-over.
Byte Bit 7 ... 0
0...1 Rated output in 0.0001mV/V
031-1CA20 - AI 1x16(24)Bit Strain gauge (DMS) > Parameter data
Analog Input
183