F
C
M
ILE AND
ONFIGURATION
ANAGEMENT
AUTOBOOT ENABLE
autoboot enable
Overview
This command enables the device to restore a release file and/or a configuration
file from external media, such as a USB storage device.
When the Autoboot feature is enabled, the device looks for a special file called
autoboot.txt on the external media. If this file exists, the device will check the
key and values in the file and recover the device with a new release file and/or
configuration file from the external media. An example of a valid autoboot.txt
file is shown in the following figure.
Figure 2-1:
Use the no variant of this command to disable the Autoboot feature.
NOTE
autoboot enable
Syntax
no autoboot enable
Default
The Autoboot feature operates the first time the device is powered up in the field,
after which the feature is disabled by default.
Mode
Global Configuration
Example
To enable the Autoboot feature, use the command:
awplus#
awplus#
awplus(config)#
Related
create autoboot
Commands
show autoboot
show boot
613-50137-01 Rev A
C
OMMANDS
Example autoboot.txt file
[AlliedWare Plus]
Copy_from_external_media_enabled=yes
Boot_Release=FS980-5.4.6-1.4.rel
Boot_Config=network1.cfg
: This command is not supported in a stacked configuration.
configure terminal
configure terminal
no autoboot enable
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
74