Centrecom FS980M/9 Command Reference Manual page 79

F C M
ILE AND ONFIGURATION ANAGEMENT
BOOT SYSTEM
To run the release file FS980-5.4.6-1.4.rel stored on the switch's USB storage device
filesystem the next time the device boots up, use the commands:
awplus#
awplus(config)#
To remove the release file FS980-5.4.6-1.4.rel stored on the switch's USB storage
device filesystem the next time the device boots up, use the commands:
awplus#
awplus(config)#
In a VCStack configuration, if there is not enough space to synchronize the new
release across the stack, the boot system command has an interactive mode that
prompts you to delete old releases.
awplus#
awplus(config)#
Answering "y" at the prompt will cause the system to delete the specified file:
awplus(config)#
Related boot config-file
Commands
boot config-file backup
boot system backup
show boot
613-50137-01 Rev A
C
OMMANDS
configure terminal
boot system usb:/FS980-5.4.6-1.4.rel
configure terminal
boot system usb:/FS980-5.4.6-1.4.rel
configure terminal
boot system FS980-5.4.6-1.4.rel
Insufficient flash available on stack member-2 (11370496)
to synchronize file FS980-5.4.6-1.4.rel 
(14821895).

List of release files on stack member-2
FS980-5.4.6-1.1.rel (14822400)

Select files to free up space,
Delete awplus-2/flash:/FS980-5.4.6-1.1.rel? (y/n)[n]:y
y
Deleting selected files, please wait............................
Successful operation
VCS synchronizing file across the stack, please wait.............
File synchronization with stack member-2 successfully completed
[DONE]
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
79