Side-To -Side Registration Adjustment - Ricoh A219 Service Manual

COPY QUALITY ADJUSTMENT

8.15 SIDE-TO -SIDE REGISTRATION ADJUSTMENT

When: Side-to-side registration is out of the adjustment standard.
Purpose: To maintain the proper side-to-side registration
0 ± 2 mm (0 ± 0.08")
Adjustment
Standard:
How to Adjust: 1. Change the lens position.
2. Change the side fence position in the paper tray.
How it works: Shift the copy image.
NOTE: 1) When side-to-side registration is out of the adjustment standard
only for the paper tray, adjust the side fence position in the paper
tray.
2) When side-to-side registration is out of the adjustment standard
for both the paper tray and the by-pass feed table, adjust the lens
position. Check the adjustment by making a copy from the by-pass
feed table. Then, make a copy from the paper tray and adjust the
side fence position in the paper tray if necessary.
-Side Fence Adjustment (Paper Tray)-
[B]
1. Pull the paper tray [A] out.
2. Move the side fences [B] to the A4 or half letter position.
3. Slide the bottom plate [C] to the front and remove it.
4. Remove the pinion gear [D].
5. Move the side fences [B] to their narrowest position and remove them.
6. Remove the registration adjustment plate [E] (2 screws).
7. Turn the registration plate 180°. The position can now be adjusted using
the long screw hole.
A219
CÓPIA NÃO CONTROLADA
[C]
[E]
[A]
A219R543.wmf
6-62
CÓPIA NÃO CONTROLADA
[D]
A219R544.wmf
SM