Setting For Automatic Mode - Siemens SINUMERIK 840D sl Operating Manual

Machine the workpiece

4.14 Setting for automatic mode

4.14 Setting for automatic mode
Before machining a workpiece, you can test the program in order to identify programming
errors early on. Use the dry run feedrate for this purpose.
In addition, you have the option of additionally limiting the traversing speed for rapid traverse
so that when running-in a new program with rapid traverse, no undesirable high traversing
speeds occur.
Dry run feedrate
The feedrate defined here replaces the programmed feedrate during execution if you have
selected "DRY dry run feedrate" under program control.
Reduced rapid traverse
This value entered here reduces the rapid traverse to the entered percentage value if you
selected "RG0 reduced rapid traverse" under program control.
Displaying measurement results
Using an MMC command, you can display measurement results in a part program:
You set
● whether, when the control reaches the command, it automatically jumps into the
● whether the window with the measurement results is opened by pressing the
118
3. Press the "Times, Counter" softkey.
The "Times, Counter" window opens.
4. Select "Yes" under "Count workpieces" if you want to count completed
workpieces.
5. Enter the number of workpieces needed in the "Desired workpieces"
field.
The number of workpieces already finished is displayed in "Actual
workpieces". This value can be corrected if necessary.
After the defined number of workpieces is reached, the current
workpieces display is automatically reset to zero.
"Machine" operating area and the window with the measurement results is displayed,
or
"Measurement result" softkey.
Operating Manual, 03/2010, 6FC5398-6AP10-4BA0
Universal