Removal Of The Ethernet Board - Mitsubishi Electric FR-F820-00077 Instruction Manual

Installation and wiring
2.9.3

Removal of the Ethernet board

The option connector 2 is not available for use because the Ethernet board is installed in the initial status.
The Ethernet board must be removed as follows to install a plug-in option to the option connector 2.
(However, Ethernet communication is disabled in that case.)
Fig. 2-61:
Remove the inverter front cover. (For details on how to remove the front cover, refer to section 2.2.)
Remove the three mounting screws to remove the Ethernet board earth plate and the Ethernet
board.
NOTES For reinstalling the Ethernet board to the inverter, remove the plug-in option installed to the
option connector 2 and install the Ethernet board and its earth plate in the reverse order.
Remove the Ethernet board on the FR-F800-E inverter to install the FR-A8NS and FR-A8AP/
FR-A8AL for the SSCNET III(/H) communication.
FR-F800
Ethernet board earth plate
Removal of the Ethernet board
System configuration for Ethernet communication (FR-F800-E)
I003106E
2 - 85