Mitsubishi Electric FR-F820-00077 Instruction Manual page 405

Parameters
Setting
Positive
logic
40
41
42
45
46
47
48
49
50
51
52
53
54
57
64
65
66
67
68
70
Tab. 5-101: Output terminal function assignment (2)
FR-F800
Signal
Function
Negative
name
logic
140 Y40 Trace status
141 FB Speed detection
142 FB2 Second speed detection
Inverter running and start
145 RUN3
command is ON
During deceleration at
occurrence of power
146 Y46
failure (retained until
release)
During PID control
147 PID
activated
148 Y48 PID deviation limit
During pre-charge
149 Y49
operation
During second pre-
150 Y50
charge operation
151 Y51 Pre-charge time over
Second pre-charge time
152 Y52
over
153 Y53 Pre-charge level over
Second pre-charge level
154 Y54
over
157 IPM During PM motor control
164 Y64 During retry
Emergency drive in
165 Y65
operation
Fault output during
166 ALM3
emergency drive
167 Y67
Power failure signal
24 V external power
168 EV
supply operation
170 SLEEP PID output interruption
(M) Monitor display and monitor output signal
Operation
Output during trace operation.
Output when the actual motor rotations
per minute (estimated rotations per
minute) reaches Pr. 42 (Pr. 50.
Output while the inverter is running and
the start command is ON.
Output after the power-failure
deceleration function operates.
(Retained until cancelled.)
Output during PID control.
Output when the absolute deviation
value exceeds the limit value.
Output during pre-charge operation.
Output when the pre-charge operation
reaches the time limit set in Pr. 764 or Pr.
769.
Output when the measured value before
reaching the ending time during pre-
charge operation is higher than the
detection level set in Pr. 763 or Pr. 768.
Output while the control method is PM
motor control.
Output during retry processing.
Output during emergency drive
operation
Output when a fault occurs during
emergency drive operation.
Output when the power failure time
deceleration-to-stop function is activated
during output shutoff due to power
failure or undervoltage.
Output while operating with a 24 V
power supply input from an external
source.
Output during PID output suspension
function operation.
Related Refer to
parameter page
Pr. 1020 to
5-443
Pr. 1047
Pr. 42, Pr. 50 5-240
⎯
5-238
Pr. 261 to
5-432
Pr. 266
Pr. 127 to
Pr. 134, Pr. 575 5-353
to Pr. 577
Pr. 127 to
Pr. 134, Pr. 553, 5-353
Pr. 554
Pr. 127 to
Pr. 134, Pr. 241,
Pr. 553, Pr. 554,
Pr. 575 to 5-385
Pr. 577, Pr. 753
to Pr. 769, C42
to C45
Pr. 71, Pr. 80,
5-48
Pr. 998
Pr. 65 to Pr. 69 5-164
Pr. 514, Pr. 515,
Pr. 523, Pr. 524, 5-167
Pr. 1013
Pr. 261 to
5-432
Pr. 266
⎯
2-61
Pr. 127 to
Pr. 134, Pr. 575 5-353
to Pr. 577
5 - 233