Mitsubishi Electric FR-F820-00077 Instruction Manual page 498

(C) Motor constant parameters
● Set a given value as the motor constant parameter. The displayed increments of the read motor
constants can be changed with Pr. 684 "Tuning data unit switchover".
First
motor
Pr.
90
92
93
706
859
Tab. 5-154: Parameter setting ranges
For the FR-F820-02330(55K) or lower and FR-F840-01160(55K) or lower.
For the FR-F820-03160(75K) or higher and FR-F840-01800(75K) or higher.
NOTES As the motor constants measured in the offline auto tuning have been converted into internal
data (****), refer to the following setting example when making setting:
Setting example:
To slightly increase Pr. 90 value (5%)
If Pr. 90 = "2516" is displayed
The value can be calculated with "2516 × 1.05 = 2641.8". Therefore set Pr. 90 = "2642".
(The value displayed has been converted into a value for internal use. Hence, simple addition of a
given value to the displayed value has no significance)
Setting "9999" disables the tuning data. The MM-EFS/MM-THE4 constant is used for the IPM motor
MM-EFS/MM-THE4, and the inverter internal constant is used for a PM motor other than MM-EFS/
MM-THE4.
Parameters referred to
Pr. 9
Pr. 71
Pr. 178 to Pr. 189
5 - 326
Second
motor Name
Pr.
458 Motor constant (R1)
Motor constant (L1)/
460 d-axis inductance
(Ld)
Motor constant (L2)/
461 q-axis inductance
(Lq)
Induced voltage
738
constant (phi f)
Torque current/
860 Rated PM motor
current
Electronic thermal O/L relay
Applied motor
(input terminal function selection)
Pr. 684 = 0 (initial value)
Setting Setting in-
Range indication
range crements
0 to 400 mΩ, 9999
0 to 500 mH, 9999
0 to 50 mH, 9999
0 to ***, 0 to 500 mH, 9999
1
9999
0 to 50 mH, 9999
0 to 5000 mV/s/rad,
0 to 500 A, 9999
0 to 3600 A, 9999
Pr. 684 = 1
Unit
indication
0 to 50 Ω, 9999 0.001 Ω
0.01 mΩ
0.01 mH
0.001 mH
0.01 mH
0.001 mH
0.1 mV/
(rad/s)
9999
0.01 A
0.1 A
=> page 5-150
=> page 5-297
=> page 5-285
Parameters
Initial
value
9999